Gunter Dewit rises to victory as Caterpillar crowns champion from Belgium in Global Operator Challenge

IRVING, Texas, October 9, 2025―The best machine operators from across Europe, Africa and Middle East gathered in Malaga, Spain to forge their legacy and prove their mastery of both equipment and technology. The 20 competitors first had to win local Cat® dealer competitions to qualify for regionals. Only three emerged victorious and earned the right to advance to the final round in the Caterpillar Global Operator Challenge (GOC) to be held in Las Vegas in March 2026. The GOC finals will take place during CONEXPO-CON/AGG inside Caterpillar’s 70,000 ft2 outdoor exhibit, F29029, in the Festival Lot.

The overall champion of the Malaga based competition was Gunter Dewit from Belgium representing dealer Bergerat Monnoyeur Belgium. Dewit finished the four GOC events with the lowest points total of 983, which is a combination of time and penalties.

At the same time, both Nicolai Thomsen from Denmark, representing dealer Zeppelin Denmark, completed the challenges with 1048 points, emerging as the first runner up and Sebastian Behr from Germany, representing dealer Zeppelin GmbH with 1101 points emerged as the second runner up. Both of these operators will also progress to the finals.

The Touchdown Challenge saw competitors using a Cat 320 hydraulic excavator fitted with 3D GPS to pick up two rugby balls consecutively and drop them in a nearby basket. Contestants then needs to touch two targets using the machines 3D GPS technology.

In celebration of a century of earthmoving excellence, the Centennial Push Challenge had operators put a Cat D4 dozer through a pre-determined course within a specified time-frame. Operators were able to use optional aids via Steer Assist and Slope Assist, which are built into the machine to help with precision maneuvers.

Featuring a Cat 938 small wheel loader, the Loader Labyrinth Challenge highlighted the agility and adaptability of the operators as they navigated a dual-phase course. Starting with a bucket, participants loaded and hauled material along a marked path before dumping it into a Cat off-highway truck. The challenge then shifted to precision handling, where operators had to swap their bucket for forks and transport a pipe across a designated route and place it accurately on the ground. After reversing the process and reconnecting the bucket safely, operators reversed through the course to the original starting position. It was a test of speed, control, and seamless equipment transitions.

The Articulator Challenge featured the recently announced next generation 730 articulated truck where competitors maneuvered the machine through a designated course. Operators had to avoid obstacles along the way before safely and precisely reversing to a pre-determined dumping area where they had to safely lower the truck body completely before returning to the travel position and coming parking correctly under a wheeled loader at the end position.